iVAC PRO MAGNETIC SWITCH

The iVAC Pro Magnetic Switch Controller has been designed to address the

needs of the UK, Europe, Australian and New Zealand markets to enable

the introduction of the complete iVAC Pro System modules, such as

In many situations in these markets Dust Extractors are fitted with a

No Voltage Reset (NVR)switch that provides power to the Dust Extractor. In the

event of a loss of A.C. Mains power, theNVR switch resets and requires manual

intervention to be set again.

There are two basic types of switches that perform the NVR function. Some are mechanically set and

some are electrically set. The iVAC Pro MSC is designed to work in conjunction with electrically set versions.

Technical assistance can be provided by your regional iVAC representative.

The iVAC Pro MSC interfaces with the Magnetic Switch of a Dust Extractor by means of a five conductor Control Cable
The iVAC Pro MSC receives digital wireless commands from either iVAC Pro Remotes or iVAC Pro Tool Plus units and then turns the Dust Extractor on or off as required, via its Magnetic Switch.
The manual Start and Stop switches on the Magnetic switch will continue to operate normally when connected to the iVAC Pro MSC.
The iVAC Pro MSC provides NVR capability when operating in the Auto or On mode.
The iVAC Pro MSC is powered from an approved Universal 5Volt 1Amp USB Power Supply, suitable for use in the UK, Europe, Australia and New Zealand.
The iVAC Pro MSC has received CE certification.